Have an enquiry? Click here to enquire directly about this product.
The patented design is unique and revolutionary, offering superb holding power on a variety of bottom types including mud, sand, gravel and rock, eliminating the need to carry two or more anchors to do the same job! Super SARCA's unique design makes it both safer and easier to use. The penetrating ability and holding power of the Super SARCA has to be experienced to be believed.
Super SARCA Anchors are designed in Australia and manufactured in Australia and New Zealand using top-quality 316 stainless steel or steel which has been hot-dip galvanized.
Features of the Super SARCA Anchors:
Super High Holding Power (SHHP) Tested and Approved by NMSC (Lloyds with a Aussie accent).
Hoop on the rear of the anchor ensures that the Super SARCA rolls over in most situations, allowing the toe to be in its best possible position to penetrate the ocean floor and reducing dragging as the fluke digs in.
No more chain tangled around and between the flukes preventing the anchor from taking hold. Super SARCA's unique tangle-resistant design improves anchor efficiency and safety.
Unique design also creates a pumping action which sinks the anchor deeper. Teamed with the Super SARCA's 360° pivoting action, this makes the Super SARCA resistant to wind and tide changes.
Incorporates an automatic reset trip release that offers you the highest rate of recovery from rocks.
When anchoring in and around bommies, reef or coral the Super SARCA has less chance of getting stuck and will create less damage to the environment Light in weight, easy to handle and contains no lead in the design to contaminate the marine environment.
Available in top-quality 316 stainless steel or hot-dip galvanized high strength Aussie made steels.
Name: No 5.
Length - shank to toe: 250mm.
Height - fluke to shank: 150mm.
Recommended for boats to 12.5m.
The recommendation is only a guide based on an average boat.
Available up to No. 15 / 145kg recommended for boats to 40m.
Any slide rail arrangement that relies on the sliding action of the D shackle must be stainless, if you use a galvanized D Shackle it will stick as galvanizing will not allow a galvanized D shackle to slide correctly, stainless does not bite in and slides like a bearing.
Further more take notice of how the D shackle is to be fitted to Super Sarca, The D shackle bolt must go through the slide rail, not the U shape of the shackle.